Signal Conditioning
Analog Input Signal Conditioning
© National Instruments Corporation
This chapter contains information about adding signal conditioning
components to the BNC-2090A and signal conditioning examples for using
the BNC-2090A with your DAQ device.
Each analog input signal has several open positions for passive signal
conditioning components. The factory-default positions for the 0 Ω jumpers
are the C and D positions of the input network, as shown in Figure 3-1. You
can remove these 0 Ω jumpers to build analog input signal conditioning
circuits. You can also add passive analog input signal conditioning, such as
filters and dividers.
3-1
3
BNC-2090A User Manual