KitchenAid KUIS155H Technical Education page 69

Service/Clean Mode (50 Min., 30 Sec.)
Enter diagnostics
(Clean is selected)
The control checks
the bin thermistor
Bin thermistor
is sensed
Check evap.
thermistor
Evap. thermistor
is sensed
Water Valve &
Cleaning LED on
(5 seconds)
5 seconds have elapsed
Condenser Fan &
Cleaning LED on
(5 seconds)
5 seconds have elapsed
Hot Gas Valve &
Cleaning LED on
(5 seconds)
5 seconds have elapsed
Recirc. Pump &
Cleaning LED on
(5 seconds)
5 seconds have elapsed
Compressor on &
Cleaning LED on
(5 seconds)
5 seconds have elapsed
The bin thermistor
is not sensed
Evap. thermistor
is not sensed
five 1 second flashes
Clean Mode (50 minutes): The Clean switch is continually
checked, and may be selected at any time.
In this section the water
valve/pump sequence
will repeat 5 times.
(30 minutes)
have elapsed
NOTE: At the end of the Clean cycle, the unit will stay OFF.
The reservoir must be drained prior to restarting the unit.
The first 30 seconds will be Service (Diagnostics)
The "Cleaning" LED
flashes off/on for
two 1 second flashes
Pause
(2 seconds)
The "Cleaning" LED
flashes off/on for
Pause
(2 seconds)
Clean Mode begins
Recirc. Pump,
Compressor, Hot Gas
Valve are energized
(20 minutes)
20 minutes have elapsed
Water Valve is
energized
(3 minutes)
3 minutes
3 minutes
have elapsed
Recirc. Pump is
energized
(3 minutes)
6-11
5 valve/pump
sequences
completed
Turn ALL
components OFF
Clean LED stays on until
manually turned off