KitchenAid KUIS155H Technical Education page 27

c) Slide the cutter grid forward and out of
the unit and place it on a work surface.
Be careful not to scratch the ice maker
liner.
d) Remove the spacer from the right cut-
ter grid bracket tab.
Slide Out Cutter Grid
e) Lift the two ice guides from the cutter
grid tabs. Note the orientation of the
guides with the straight side facing in.
There should be a slight outward tilt
after the guides are installed. Bend the
metal tabs outward, if necessary.
Cutter Grid
Ice Guides
Position Ice Guide
With Straight Side
As Shown
8. To remove the evaporator thermistor:
a) Remove the cutter grid from the unit
(see step 7 on page 4-2 for the proce-
dure).
b) Disconnect the evaporator thermistor
connector from the bottom of the con-
trol housing.
c) Remove the two hex-head mounting
screws from the water trough and pull
the trough from the unit.
Control Housing
Spacer
d) Reach behind the accumulator, and
unclip the evaporator thermistor from
the evaporator tubing and remove it.
Bottom Of The Evaporator
4-3
Evap Thermistor Connector
Water Trough Screws
Water Trough
Evaporator Thermistor
Accumulator
Continued on the next page.