Removing The Bin Thermistor, Cutter Grid, Evaporator Thermistor, & Water Distributor - KitchenAid KUIS155H Technical Education

REMOVING THE BIN THERMISTOR, CUTTER GRID,
EVAPORATOR THERMISTOR, & WATER DISTRIBUTOR
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug ice maker or disconnect power.
2. Open the ice maker door.
3. Cover or remove the ice from the storage
bin.
4. Place a cloth in the drain hole to prevent
hardware from falling inside.
5. Remove the two hex-head screws from
the cutter grid cover and remove the cover.
Cutter Grid Cover
Cutter Grid Cover Screws
Cutter Grid Cover
6. To remove the bin thermistor:
a) Disconnect the bin thermistor connec-
tor from the bottom of the control hous-
ing.
b) Pull the bin thermistor out of the retain-
ing clamp and remove it.
Control Housing
Bin Thermistor
Retaining Clamp
7. To remove the cutter grid:
a) Disconnect the cutter grid and bin ther-
mistor connectors from the bottom of
the control housing.
b) Remove the two hex-head screws from
both sides of the cutter grid.
Bin Thermistor Connector
Cutter Grid Connector
Cutter Grid Screws
4-2
Connector
Spacer Bracket (Left Side)
18" Models