Table of Contents
Advertisement
WARNING
Storage batteries give off explosive
hydrogen gas during recharging.
Slightest spark will ignite hydrogen
and cause explosion.
Battery electrolyte fluid contains acid
and is extremely caustic.
Contact with battery contents will
cause severe chemical burns.
A battery presents a risk of electrical
shock and high short circuit current.
•
DO NOT dispose of battery in fire.
•
DO NOT allow any open flame, spark,
heat, or lit cigarette during and for several
minutes after charging a battery.
•
DO NOT open or mutilate the battery.
•
Wear protective goggles, rubber apron,
and rubber gloves.
•
Remove watches, rings, or other metal
objects.
•
Use tools with insulated handles.
5. Connect negative battery cable to negative
battery terminal (indicated by NEGATIVE,
NEG, or (-)).
6. Ensure hardware on both positive and
negative battery terminals is secure.
7. Reinstall 15 Amp fuse in control panel.
CAUTION
Installing the control panel's 15A fuse
could cause the engine to start.
•
DO NOT install this fuse until all plumbing
and wiring has been completed and
inspected.
8. Set generator's system switch to AUTO.
9. Reset exercise timer. See Setting Exercise
Timer.
Servicing the Battery
If it is necessary to service the battery, proceed
as follows:
1. Set control board System switch to OFF.
2. Remove 15 Amp fuse from control panel.
3. Service or replace battery as required.
4. Connect red battery cable to battery positive
terminal (indicated by POSITIVE, POS, or (+)).
5. Connect negative battery cable to negative
battery terminal (indicated by NEGATIVE,
NEG, or (-)).
6. Ensure hardware on both positive and
negative battery terminals is secure.
7. Reinstall 15 Amp fuse in control panel.
8. Set generator's system switch to AUTO.
9. Reset exercise timer. See Setting Exercise
Timer.
To Clean the Generator
NOTICE
Improper treatment of generator can damage
it and shorten its life.
•
DO NOT expose generator to excessive
moisture, dust, dirt, or corrosive vapors.
•
DO NOT insert any objects through cool-
ing slots.
• Use a damp cloth to wipe exterior
surfaces clean.
• Use a soft bristle brush to loosen caked
on dirt, oil, etc.
• Use a vacuum cleaner to pick up loose
dirt and debris.
• Use low pressure air (not to exceed 25
psi) to blow away dirt. Inspect cooling air
slots and openings on the generator.
These openings must be kept clean and
unobstructed.
1
15
Hide quick links:
Advertisement
Table of Contents
