HP C2246 Technical Reference Manual page 31

Interface Connectors and Cables
Connector Dimensions and Locations
The physical locations and dimensions of the interface connectors are shown in the respective
appendices for each interface PCA. Refer to Table 2-1 for a list of these appendices.
SCSI Connector
The SCSI device connector is a nonshielded 50-pin (narrow drives) or a 68-pin (wide drives)
connector. The physical construction and pin assignments for the connectors conform to
SCSI specifications. Mating connector information is listed in Table 2-3. The connector pin
assignments are listed in the respective appendices for each interface PCA (refer to Table 2-1).
DC Power Connector
Power requirements for the disk drive are listed in Chapter 1. Pin assignments for the de
power connector are shown in the respective appendices for each interface PCA (refer to Table
2-1). Mating connectoi:, information is listed in Table 2-3.
Mating Connector Requirements
Table 2-3. Recommended Mating Connectors
Connector /Function
Recommended Mating Connector
Equivalents may be used.
SCSI Connector (narrow: 3M® 3425-6600
single-ended and differential}
SCSI Connector (wide: differential) AMP® 786090-7
DC Power AMP® 1-480424-0
Synchronized Spindle Connector
AMP® Housing 4-87456-9
1
Shorting jwnpers (2.0 mm spacing) 2xl shorting jumper: Dupont® 86730-001 (HP p/n 1258-0209)
2x2 connector housing: Dupont® 69307-004
2
2x3 connector housing: Dupont® 69307-006
2
2x5 connector housing: Dupont® 69307-010
2
Notes:
1. Contact insert required; refer to vendor documentation to select the proper contact set for the installed wire size.
(For AWG 20-24 wire, use AMP® 1-87309-4.)
2. Contact inserts required; refer to vendor documentation to select the proper contact set for the installed wire size.
(For AWG 2&-30 wire, use Dupont® 77138-101; for AWG 32-36 wire, use Dupont® 77139-101.)
Product Installation 2-9