HP C2246 Technical Reference Manual page 151

Narrow, Single-Ended Drive Configurations
wspdm202
t
1.625
(4127)
~l~~~l ~~-"--~~·~
l
! . . . .
1.625 ..
1...
1.80 248
(41.28)
l
{45.72l .30l
i . ..
2.375 .625
(60 32> (15.88)
3.75
(95.ZSl
4.00
1101.60)
Figure E-1. Narrow, Single-Ended: Disk Drive Dimensions and Mounting Locations
Mounting Guidelines:
1.
Values given in inches and (millimeters).
E
2. Maintain a minimum clearance of 0.06 in. (1.5 nun) between any system structure and the top and all four sides of
the rusk drive. Insure that the system structure contacts only the drive mounting frames and clears the drive HDA
by at least 0.06 in. (1.5
:mm:).
3. Maintain a minimum clearance of 0.04 in. (1.0 mm) between any system structure and
any
PCA compoment.
4. Use 6-32 UNC screws with flat washers under the heads and torque them to 15 inch-pounds.
5. When mounded, the screws should not protrude more than 0.12 in. (3 mm) beyond the inside of the disk drive
mounting frame.
Narrow, Single-Ended Drive Configurations E-1