HP C2246 Technical Reference Manual page 146

Error Code
Hex(Dec}
2A{42}
2B(43)
20(44)
2D(45)
2E(46)
2F(47)
thru
31(49)
32(50)
33(51)
34(52)
35(53)
36(54)
37(55)
38(56)
39(57)
3A(58)
3B{59)
3C(60)
30(61)
3E(62)
3F(63)
40{64)
41(65)
42(66)
43(67)
44{68)
45(69)
46(70)
47(71)
48(72)
49(73)
4A{74)
4B{75)
4C(76)
40(77)
4E{78)
4F(79)
thru
7F(l27)
Table C·1. Vendor Unique DERROR Status Codes (continued)
Description
HDA EEPROM test byte is not 55H.
HDA EEPROM checksum result not equal to 00.
PCA EEPROM test byte is not 55H.
PCA EEPROM checksum result not equal to 00.
Computed read/write setting is out of range.
Reserved.
The long term DSP command completed with Alert signal set in status register.
The DSP Alert signal was set when attempting to send a. command to the DSP.
Request Status logged a. Servo Fault from the fault register.
DSP failure code indicates other than Reset at power-on.
Reserved.
Reserved.
Maximwn DC head alignment correction capability
was
exceeded.
Maximum AC head alignment correction capability was exceeded.
Maximwn iteration limit was exceeded in calibrating
t~e
NPES gain.
SPES gain not witltln acceptable level.
Reserved.
Reserved.
Write current unsafe.
Command requires a special test 'enable to be executed.
Unknown write fault.
Write during loss of servo timing sync.
Write during momentary spindle off-speed indication.
Write during momentary actuator off-track indication.
Write during a seek operation.
Write after settle or tracking failure.
Write following aggressive settle.
Not defined.
Write was attempted wltlle ESDI attention was asserted.
Write was attempted while an illegal head was selected.
Write was attempted while a recalibrate was in process.
Write was attempted on a head that was in the head alignment critical state.
Write was attempted while a head aligrunent was in process.
Write was attempted after a fatal head aligrunent occurred.
Write was attempted while spun down or after a recalibrate failure.
Reserved.
C-2 Vendor Unique Status Codes