Appendix D Wireless/Spectrum Approvals - Emerson AMS Trex User Manual

Appendix D
Wireless/Spectrum approvals
Wireless/Spectrum approvals
FCC and
IC
NTC
(Thailan
d)
User Guide
Radio frequency radiation exposure Information: For body worn operation, this
device has been tested and meets FCC RF exposure guidelines.
Information sur l´exposition aux rayonnements des ondes radio : Pour le port sur une
partie du corps, les directives de la FCC en rapport avec l'exposition aux fréquences RF ont été
testées et respectées.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTICE:
This device complies with Part 15 of the FCC Rules and with Industry Canada licence-
exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
NOTICE:
Changes or modifications made to this equipment not expressly approved by R. Stahl
HMI Systems may void the FCC authorization to operate this equipment.
NOTICE : This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This telecommunication equipment conforms to NTC technical requirements.
Wireless/Spectrum approvals
193