Maintenance And Repair; Replace The Stand; Calibration - Emerson AMS Trex User Manual

AMS Trex Device Communicator overview
2.16

Maintenance and repair

Any maintenance, repair, or replacement of components not listed below must be
performed by specially trained personnel at an authorized service center. You can perform
common maintenance procedures listed below:
•
•
•
•
•
•
•
2.16.1

Replace the stand

1.
2.
3.
4.
5.
6.
2.16.2

Calibration

Calibration is not supported on the AMS Trex Device Communicator. Voltage, current,
signal, and noise measurements made by the Trex unit are intended for troubleshooting
purposes. NIST standards are not applicable to the AMS Trex Device Communicator.
44
Clean the exterior. Use only a dry, lint-free towel or dampen the towel with an
alcohol or mild soap and water solution.
Clean the touchscreen.
Install, remove, or charge the power module.
Remove and replace the stand.
Ensure that all exterior screws are sufficiently tightened.
Ensure the communication terminal recess is free of dirt and debris.
Install and remove the communication module.
Place the Trex unit face down on a level, secure surface.
Lift up the stand.
®
Use a Torx screwdriver to loosen and remove the two screws under the stand.
Remove the stand.
Place the new stand on the Trex unit.
Insert and tighten the two screws. Do not over tighten the screws. Use 0.5Nm
maximum torque load.
User Guide