Change The Tag For A Foundation Fieldbus Device - Emerson AMS Trex User Manual

Field Communicator application
2.
3.
4.
5.
6.
7.
8.
3.21.6

Change the tag for a FOUNDATION fieldbus device

Note
You cannot change the tag when the device is commissioned or a host/linking device is detected on
the fieldbus segment. To change the tag, use the host system or remove the device from the fieldbus
segment and connect it directly to the Trex unit.
Procedure
1.
2.
3.
4.
5.
6.
7.
110
Go to the parameter you want to change.
See the device documentation for more information. Each device uses different
menus.
If prompted, select if the device is commissioned.
Change the parameter.
Note
The Trex unit may disconnect from the device after you make the change. If this occurs, the
change is automatically sent to the device without any additional input from you.
Tap Send.
Review the change.
Tap Discard to undo the change and close the screen. Tap Cancel to keep the change
and send it to the device at a later time.
Tap Send.
Tap OK.
Connect to the FOUNDATION fieldbus device.
Tap Service Tools.
Tap Physical Device Tag.
Tap OK when prompted that the device will be restarted after the parameter is
changed.
Tap Yes or No when asked if the device is commissioned.
You cannot make changes if the device is commissioned.
Enter a new tag, and tap OK.
The Trex unit disconnects from the device.
Tap OK on the message that indicates the device has been disconnected from the
Trex unit.
The Device List appears and displays the device with the new tag.
User Guide