Fitting The Open Array To The Pedestal - Raymarine Pathfinder Radar Scanner Owner's Handbook Manual

34

Fitting the open array to the pedestal

CAUTION:
The pedestal unit has a cap fitted over the open array mounting
shaft to protect the protuding co-axial pin. This cap must be left in
place until the open array is fitted to the pedestal.
1. Remove the cap from the open array shaft. Retain the cap, it will be required if
the open array is removed from the pedestal.
2. Grease the four securing studs with Denso paste (supplied).
CAUTION:
If the pin is damaged during the following operation you should
contact your service dealer.
3. Lift the open array into position. Carefully lower the array - to prevent damage
to the mounting pin, ensure the array remains parallel to the pedestal so that
the studs slot into the holes on the pedestal mounting bracket.
The open array mounting bracket is designed so that the array can only be fitted to
Note:
the pedestal in the correct orientation.
4. Use the four nuts and associated washers supplied to secure the array to the
pedestal as shown in the diagram below.
Pathfinder Radar Scanners
Array
Pedestal
M8 plain washer
M8 spring washer
M8 nut
D4580-2