General Maintenance; Routine Checks; Caution: Do Not Dismantle Smartpilot Products; Cleaning The Display - Raymarine ST6002 Operating Manual

30
ALARM MESSAGE
RG FAIL
SEATALK
FAIL 1 2
or
SEATALK

3.2 General maintenance

Routine checks

CAUTION: Do not dismantle SmartPilot products

The SmartPilot computer and controller should be serviced only
by authorized Raymarine service technicians. These products do
not contain any user serviceable parts.
The SmartPilot computer does NOT contain user-serviceable parts. If you remove
the main cover you will invalidate the warranty. The controller is also a sealed
unit, so user maintenance is limited to the following checks
• make sure all cable connectors are firmly attached
• examine for signs of wear or damage – replace any damaged cables
Do not use chemical or abrasive materials to clean the SmartPilot computer. If the
Note:
case is dirty, wipe it with a clean, damp cloth.

Cleaning the display

CAUTION: Avoid damage when cleaning

Take care when cleaning the display. Avoid wiping the display
screen with a dry cloth as this could scratch the screen coating. If
necessary, use only a mild detergent.
• Never use chemical or abrasive materials to clean the controller. If it is dirty,
wipe it with a clean, damp cloth.
• In certain conditions, condensation may appear inside the display screen. This
will not harm the unit, and you can clear it by switching on the illumination for
a short time.
POSSIBLE CAUSE and SOLUTION
GyroPlus yaw sensor has failed:
• If you have a S1G, S2G or S3G course computer with internal
GyroPlus sensor – call a Raymarine service agent.
• If you have a Non-G
yaw sensor – check the sensor and connections, then call a Ray-
marine service agent.
SeaTalk data problem on one of the SeaTalk lines – check connec-
and
tions.
The control unit cannot transmit data to the SeaTalk system. Make
FAIL
and
sure all SeaTalk cables are connected properly.
ST6002 SmartPilot Controller Operating Guide
s
course computer with external GyroPlus