Suppression Ferrites; Connections To Other Equipment - Raymarine GPS Plotter Owner's Handbook Manual

5-2
• Raymarine specified cables are used. Cutting and rejoining these
cables can compromise EMC performance and must be avoided unless
doing so is detailed in the installation manual.
• If a suppression ferrite is attached to a cable, this ferrite should not be
removed. If the ferrite needs to be removed during installation it must
be reassembled in the same position.

Suppression Ferrites

The following illustration shows typical cable suppression ferrites used
with Raymarine equipment. Always use the ferrites supplied by
Raymarine.

Connections to Other Equipment

If your Raymarine equipment is to be connected to other equipment using
a cable not supplied by Raymarine, a suppression ferrite MUST always
be attached to the cable near to the Raymarine unit.
Figure 5-1: Typical Suppression Ferrites
Raynav 300 GPS Plotter
D3548-2