Raymarine GPS Plotter Owner's Handbook Manual page 72

Chapter 3: Operation
Naming, Erasing and Showing a Track
➤
To name an existing track, erase a track or show a track:
1. Press the TRACK LIST soft key; the Track List is displayed.
2. Using the trackpad top/bottom, select the required track and press the
3. To NAME a track, use the trackpad left/right to select the character you
4. Press ENTER to finish the operation or CLEAR to cancel the name.
5. To ERASE a track you are prompted to confirm:
6. If you select SHOW a track when a current, unsaved track is displayed,
The highlight indicates the selected track.
SAVE TRACK , NAME TRACK or ERASE TRACK soft key.
wish to edit and the trackpad top/bottom to change the character.
i. Press NO to cancel the operation, then ENTER if you wish to
remove the Track List.
ii. Press YES to erase the track from the Track List, then ENTER to
remove the Track List.
you are prompted to save the current track. Proceed as described in
Clearing the Current Track on page 3-41 or press the NO soft key to
cancel the operation.
The Track List is removed and the selected track is displayed.
3-43