Set Icslan - AMX NX-1200 Webconsole And Programming Manual

Terminal Commands (Cont.)
Command

SET ICSLAN

SET ICSP PORT
SET ICSP TCP TIMEOUT
SET IP <D:P:S>
SET LOCKOUT
NX-Series Controllers - WebConsole & Programming Guide
Description
Sets the ICSLAN port settings.
Example:
>set icslan
--- Enter New Values or just hit Enter to keep current settings
Enter ICSLan Host Name:
Enter ICSLan Network octet 1:
Enter ICSLan Network octet 2:
Disable DHCP Server? (Y):
See the Using the ICSLAN Network section on page 120 for more information.
Sets the Master's IP port listened to for ICSP connections.
NOTE: The Master must be rebooted to enable new settings.
Example:
>SET ICSP PORT
Current ICSP port number = 1319
Enter new ICSP port number (Usually 1319)
(0=disable ICSP):
Once you enter a value and press the ENTER key, you receive the following message:
Setting ICSP port number to
New ICSP port number set, reboot the Master for the change to
take affect.
Sets the timeout period for ICSP and i!-Web Control TCP connections.
NOTE: The new timeout value is immediately (no reboot required).
Example:
>SET ICSP TCP TIMEOUT
This will set the timeout for TCP connections for both ICSP and i!-Web
Control.When no communication has been detected for the specified number of
seconds, the socket connection is closed.ICSP and i!-Web Control have built-in
timeouts and reducing the TCP timeout below these will cause undesirable
results. The default value is 45 seconds.
The current ICSP TCP timeout is 45 seconds
Enter new timeout (in seconds):
Once you enter a value and press the ENTER key, you receive the following message:
New timeout value set (in affect immediately).
Sets the IP configuration of a specified device.
Enter a Host Name, Type (DHCP or Fixed), IP Address, Subnet Mask, and Gateway IP Address.
NOTE: On a Master, the host names may contain only the ASCII letters 'a' through 'z'
(case-insensitive), the digits '0' through '9', and the hyphen ('-').
• Enter Y (yes) to approve/store the information into the Master.
• Enter N (no) to cancel the operation.
NOTE: The Device must be rebooted to enable new settings.
Example:
>SET IP [0:1:0]
--- Enter New Values or just hit Enter to keep current settings ---
Enter Host Name: MLK-INSTRUCTOR
Enter IP type. Type D for DHCP or S for Static IP and then Enter: DHCP
Enter Gateway IP: 192.168.21.2
You have entered: Host Name
Type
Gateway IP
Is this correct? Type Y or N and Enter -> y
Settings written. Device must be rebooted to enable new settings.
Sets the number of failed logins on a user account before the user account is locked.
Example:
>SET LOCKOUT 10
Terminal (Program Port/Telnet) Commands
ICSLAN
198
18
MLK-INSTRUCTOR
DHCP
192.168.21.2
113