Table of Contents
Advertisement
43-775.fm Page 14 Friday, August 13, 1999 3:25 PM
• About once a month, fully dis-
charge the battery by keeping the
handset off the base until the
BATT LOW indicator flashes. Oth-
erwise, the battery loses its ability
to fully recharge.
• If the BATT LOW indicator does
not light, but the phone does not
work, recharge the battery. (The
battery charge might be too low to
light the indicator.)
• If the battery pack gets weak dur-
ing a call, a beep sounds about
every 30 seconds, and the BATT
LOW indicator flashes about every
3 seconds. If this happens, you
cannot make another call using
the handset until you recharge the
battery.
• If the battery loses its charge com-
pletely, the TAD-1016 loses the
security access-protection code.
Place the handset on the base
and charge the battery; this also
resets the code.
• The supplied battery should last
about a year. When the battery
loses its ability to fully recharge,
order a replacement battery (see
"Replacing the Battery Pack" on
Page 34).
14
SETTING THE DIALING
MODE
Set
on the back of the base for
P
T
the type of service you have. If you
are not sure which type you have, do
this test.
1. Set
to
(tone).
P
T
T
2. Press
and listen for a
SPEAKER
dial tone.
3. Press any number other than
Note: If your phone system re-
quires that you dial an access
code (
, for example) before you
9
dial an outside number, do not
press the access code either.
If the dial tone stops, you have
touch-tone service. Leave
set to
.
T
If the dial tone continues, you
have pulse service. Set
(pulse).
4. To hang up, press
.
0
P
T
to
P
T
P
SPEAKER
.
Advertisement
Table of Contents
