Table of Contents
Advertisement
43-775.fm Page 22 Friday, August 13, 1999 3:25 PM
TAD OPERATION
You can use the base or the handset
to control the TAD. With the handset
you set the day and time, the remote
operation personal identification num-
ber, record outgoing messages and
memos, turn the TAD on and off, play
messages, and delete messages. At
the base you can set the number of
rings before the TAD answers an in-
coming call, set the kind of outgoing
message played and the incoming
message recording time, turn the TAD
on and off, play and delete messages,
and adjust the TAD's volume.
USING THE HANDSET
TO CONTROL THE TAD
To set the handset to control the TAD,
lift the handset. If the BATT LOW indi-
cator lights red, press
off. Then press
REMOTE
LOW indicator on the handset lights
green, and three bars flash alternately
on the base's display.
The TAD tells you the number of mes-
sages you have (if any), then an-
nounces the help messages through
the handset. Then the TAD beeps
when it is ready to accept a command.
22
Notes:
When you finish operating the TAD,
press
the handset to make and receive calls.
SETTING THE NUMBER
OF RINGS
Set the
of the base to select how long the
TAD waits before it answers a call
to turn it
(two rings, five rings, or toll-saver).
TALK
. The BATT
Note: If you plan to check your mes-
sages by long distance, set the num-
ber of rings to toll-saver (see "Using
the Toll-Saver" on Page 29).
• You can skip the message count
and the help messages by imme-
diately entering a command.
• If you need help during operation,
press
. The TAD plays a
HELP/0
series of voice prompts to guide
you through TAD options.
again so you can use
REMOTE
switch on the side
RING TIME
Advertisement
Table of Contents
