Table of Contents
Advertisement
pack through RadioShack. Install the new battery pack and
charge it for about 15–20 hours. If you have trouble
replacing the battery pack, take the phone to your local
RadioShack for assistance.
5
"
"4
'66+0)
6*'
+0)'4
You can select either a high or low ringer tone setting on the
handset while the phone is not in use. Lift the handset and
press
to hear the current ringer setting. Repeat-edly
VOL
press
to select the desired ringer setting.
VOL
5
"
"&
'66+0)
6*'
+#.+0)
Your phone is set for tone dialing. If you have pulse service,
change the dialing mode. If you are not sure which type of
service you have, do this test.
1. Lift the handset, press
2. Press any number other than
If the dial tone stops, you have touch-tone service. If the dial
tone continues, you have pulse service.
To set the dialing mode, hold down
beeps and TALK/BATT flashes, then press # to set the phone
∗ ∗ ∗ ∗
to pulse mode or
TONE/
12'4#6+10
/
"
"4
#-+0)
#0&
'%'+8+0)
To make a call, lift the handset and press
call, simply lift the handset. Or, if the handset is not in place
on the base, press
TALK
TALK/BATT indicator on the handset and the CHARGE/IN
USE indicator on the base light.
To end a call, place the handset on the base or press
The TALK/BATT and CHARGE/IN USE indicators turn off. ±
5
"
"%
'.'%6+0)
6*'
*#00'.
The phone scans 20 channels (frequency pairs used be-
tween the base and the handset) and automatically selects
a clear channel each time you make or receive a call.
If you hear other conversations or you experience difficulty
hearing the conversation, press
channel. TALK/BATT flashes, then there is a brief pause as
your phone searches for a clear channel. ±
"6
10'
"/
1&'
, and listen for a dial tone.
TALK
. ±ý
0
until the phone
FLASH
to set the phone to tone mode.
"%
#..5
. To answer a
TALK
or any number key, #, or
to select a different
CH
±
Setting the Dialing Mode
• If your phone system requires
that you dial an access code (9,
for example) before you dial an
outside number, do not dial the
access code.
• The phone exits setting mode if
a call or page is received, or if
you press END.
• If the battery power becomes
too low, the dialing mode might
reset to tone. If you are on a
pulse line and cannot make a
∗ ∗ ∗ ∗
. The
call, try setting the dialing mode
to pulse.
Making and Receiving Calls
If the handset is too far from the
.
END
base while the phone is in use,
pressing END might not disconnect
the phone. Hang up the handset on
the base.
Selecting the Channel
If the handset is too far from the
base, an error tone sounds and the
channel might not change. Move
closer to the base.
±
"016'"
"
7
Advertisement
Table of Contents
