Setting The Dialing Mode; Setting The Ringer Tone/Volume - Radio Shack Cordless Telephone Owner's Manual

• About once a month, fully discharge the
battery pack by keeping the handset off
the base until the TALK/BATT indicator
flashes. Otherwise, the battery pack
loses its ability to fully recharge.
• If the TALK/BATT indicator does not light
and the phone does not work, recharge
the battery pack. (The battery power
might be too low to light the indicator.)
• If the battery pack becomes weak during
a call, you hear a beep every 3 seconds
and the TALK/BATT indicator flashes
every 3 seconds. Recharge the battery
pack.
• If the battery pack is completely dis-
charged, the handset loses the security
access-protection code. To reset the
code, place the handset on the base and
charge the battery pack.
The supplied battery pack should last about
one year. If the battery pack does not hold a
charge for more than 2 hours after an over-
night charge, replace it with a new 3.6-volt,
600 mAh battery pack with a connector that
fits the socket in the battery compartment.
You can order a replacement battery pack
through your local RadioShack store.
Warning: Dispose of the old battery pack
promptly and properly. Do not burn or bury it
(see "BATTERY SAFETY INSTRUCTIONS" on
Page 4 for additional information on proper bat-
tery handling).
If you have trouble replacing the battery, take
the phone to your local RadioShack store for
assistance.
Important: The EPA certified
®
RBRC Battery Recycling Seal
on the nickel-cadmium (Ni-Cd)
battery indicates RadioShack is
voluntarily participating in an in-
dustry program to collect and recycle these
batteries at the end of their useful life, when
taken out of service in the United States or
Canada. The RBRC program provides a con-
venient alternative to placing used Ni-Cd bat-
teries into the trash or the municipal waste
stream, which may be illegal in your area.
Please call 1-800-THE-SHACK (1-800-843-
7422) for information on Ni-Cd battery recy-
cling and disposal bans/restrictions in your ar-
ea. RadioShack's involvement in this program
is part of the company's commitment to pre-
serving our environment and conserving our
natural resources.

Setting the Dialing Mode

Your phone comes set for tone dialing. If you
have pulse service, you need to change the
dialing mode. If you are not sure which type of
service you have, do this test.
Lift the handset and listen for a dial tone.
Press any number other than
Note: If your phone system requires that you
dial an access code (
you dial an outside number, do not press the
access code.
If the dial tone stops , you have touch-tone ser-
vice. If the dial tone continues , you have pulse
service.
To set the dial mode, hold down
the phone beeps and the TALK/BATT indica-
tor flashes, then press # to set to pulse mode
∗ ∗ ∗ ∗
or to set to tone mode.
TONE/
Note: The phone exits setting mode if a call or
page is received, or if you press
If the battery pack power becomes too low,
the dial mode might reset to tone. If you are
on a pulse line and cannot make a call, try set-
ting the dialing mode to pulse.

Setting the Ringer Tone/Volume

You can select either a high or low ringer
tone/volume setting while the phone is not in
use.
Press to hear the current ringer set-
VOLUME
ting. Repeatedly press
the desired ringer setting.
6
.
0
, for example) before
9
until
FLASH
.
TALK
until you hear
VOLUME