Table of Contents
Advertisement
Installation Instructions
Starting up the SmartKey Code Keypad Without Reader
(or changing user codes)
Notes on operation
-
The user code for the NZ 300 LSN and "integrated" SmartKey is described in detail in the
NzPara online help under "User Codes" (different default setting).
Define your user code during the first start-up. User codes can always be changed at a later
-
date. Both operational procedures are identical.
User codes always have 6 digits; the default code is 000000.
-
The user code can only be changed when the system is disarmed. The system cannot be ar-
-
med while a user code is being changed.
Code entry can be aborted by pressing the "C" key. The buzzer sounds intermittent tones for
-
6 seconds. The LEDs are deactivated.
If the user code is entered incorrectly three times, a wait period of 5 minutes begins. The buz-
-
zer sounds intermittent tones for 6 seconds. The LEDs are deactivated. If another incorrect
entry is made, another waiting period of 5 minutes follows.
Provided the yellow LED on the code keypad has been correctly programmed and connected
to the C-point of the control unit, a blocked code keypad can be indicated during a system sta-
tus query by the yellow LED, which lights up for approximately 5 seconds.
A maximum interval of 1 minute is permitted between each operational step when operating
-
the code keypad. The initiated operation will be aborted if no input is made during the 60-
second period.
Notes on the user code
User number (ID) = 1 to max. 3 digits depending on the control panel
-
User code = always 6 digits
-
User code = user number (ID) + 6 digit user code
-
Continued overleaf.
General information: The code keypad allows arming and
disarming of the intrusion alarm system only after the correct
combination of numbers has been entered on the code key-
pad.
Hold-up code: If someone is forced to disarm the intrusion
alarm system under duress, a silent alarm (hold-up alarm)
can be triggered via the code keypad by increasing the value
of the last digit of the user code; this is programmable be-
tween the values 1 and 9.
28
Advertisement
Table of Contents
