Table of Contents
Advertisement
Starting up the SmartKey Code Keypad Without Reader
(or changing user codes)
!
The user code for the NZ 300 LSN and "integrated" SmartKey is described in de-
tail in the NzPara online help under "User Codes" (different default setting).
Define user code or change user code
(when the system is disarmed) as follows:
1. Simultaneously press the "C" and "
The keypad's buzzer will sound for 1 second and the red and green LEDs will flash.
2. Enter your user number (ID).
The buzzer will sound for 1 second and the LEDs will be deactivated.
3. When starting up for the first time, enter "000000" and confirm your input with the "
- or,
If you want to change the 6-digit user code, enter the "old user code" and confirm your input
with the "
" key.
The code keypad's buzzer will sound for 1 second and the green LED will light up.
4. Enter the new user code and confirm your entry with the "
The code keypad's buzzer will sound for 1 second, the green LED will light up and the red
LED will flash.
5. Enter the new user code once again and confirm your entry with the "
The code keypad's buzzer will sound for 3 seconds, and the green and red LEDs will light
up for 3 seconds and then go out.
The new user code is now valid.
Installation Instructions
Define your user code during the first start-up. You can
change your user code at a later date. Both operational
procedures are identical.
Use this key to verify entries.
Use this key to abort an operation.
" keys for 3 seconds.
29
" key.
" key.
" key
Advertisement
Table of Contents
