Table of Contents
Advertisement
Installation Instructions
Installing System Components
Note the following during installation:
!
Used shielded cables only.
The usual precautionary measures for C-MOS technology apply to handling the cir-
cuit boards and to soldering work. Wear a grounded wrist strap when working on the
control panel.
Mounting the control unit
Mount the control unit to the wall. When choosing a position to mount the unit,
!
please note that the reader and SPE blocking element are equipped with a 6 m molded
cable that must not be lengthened.
Mounting the reader
Mount the reader according to the enclosed instruction leaflet.
!
If you have to install the reader close to other systems with proximity readers, please
make sure that you leave a distance of at least 0.5 m.
The reader should be installed at a height of at least 1.2 m and preferably recessed
mounted. The reader is molded and completely resistant to environmental influences.
Do not fit the reader cover until you have performed all the function tests. Removing the
cover after it has been fitted will cause damage to the cover. The reader is equipped
with a 6 m molded cable that must not be lengthened.
Installing the code keypad
The code keypad must be installed outside of the security area close to the assigned door
(next to the reader because of the LED and buzzer) and protected from atmospheric
!
conditions. Make sure that the code keypad is not visible to other persons during use.
Install the code keypad in accordance with the installation instructions enclosed with
the device. Make sure the membrane supply line does not get broken when fitting the
membrane keypad. The SmartKey keypad unit is equipped with a 6 m molded cable
that must not be lengthened.
Important information for lockable code keypad: Connect points LF1 and LF2 with a
solder bridge as described in the code keypad installation instructions if you want to
enable user codes to be changed using the keypad.
8
Advertisement
Table of Contents
