Terminal Connector Pin Assignments; 10Base-T And 100Base-T Connector - Wyse 3315SE Reference Manual

44
Terminal Connector Pin
Assignments

10Base-T and 100Base-T Connector

The following figure shows the pin assignments for the 10Base-T and 100Base-T
connector. This connector is located on the back panel of your terminal. See
"Terminal Features" for information about the back panel.
Figure 44-1 10Base-T and 100Base-T Connector
1 8
RJ-45
Note
It is recommended that you use Category 5 twisted-pair
cable to connect your terminal to a hub.
Terminal
10Base-T
Connector
Pin Signal Name
1 +Transmit Detect
2 -Transmit Detect
3 +Receive Detect
6 - Receive Detect
Hub