Mitsubishi Electric QS001CPU User Manual page 84

10
LOADING AND INSTALLATION
1)
Loosen the screw at the top of the
stopper. (2 stoppers)
2) Hitch the lower hook of the stopper
to the bottom of the DIN rail. Install
the stopper with the arrowhead side
facing up.
3) Hitch the upper hook of the stopper
to the top of the DIN rail.
4) Slide the stopper to the end of the
base unit so that they are fully in
contact.
5) Tighten the screw of the stopper
with a screwdriver.
(Tightening torque 1.00 to 1.35N∙m)
Make sure that the left and right
stoppers are fixed securely to the
DIN rail.
10
- 10 10.2 Module Installation
10.2.1 Installation precautions
(e) Stopper mounting
When using the DIN rail in a large vibration and/or shock prone environment,
install the base unit using the stoppers supplied with the DIN rail adapters
indicated in (a).
Complete
Figure 10.10 Fixture mounting procedure
Hook
Stopper
1)
Hook
3) Hitch the hook to top of
the DIN rail
2)
Hitch the hook to bottom
of the DIN rail
Stopper
4)
DIN rail
(Left side)
5)
(Right side)
Stopper
5)
Stopper
4)
DIN rail
Stopper