Programming Motorola Trunking Systems (Uhf-Lo) - Radio Shack PRO-93 Owner's Manual

8 8 8 8
to access the next open channel then enter the
frequencies. (See "Storing Known Frequencies into
Channels" on Page 25).
,òòñUôô ,òòñUôô
,òòñUôô ,òòñUôô
â8EBýòý â8EBýòý á?ýòñ â8EBýòý â8EBýòý
7. Press
SCAN
Notes:
• If you make an error in the entry process, press
as often as needed to erase the incorrect data.
• If you enter a frequency that has already been
entered, the scanner sounds an error tone and dis-
plays
LGCôý= LGCôý=
LGCôý= LGCôý=
duplicated. If the dual entry is an error press
enter the correct frequency. If the dual entry is inten-
tional press
ENTER
• You may replace any frequency by selecting the
bank and channel, pressing
new frequency.
Programming Motorola Trunking Systems
(UHF-Lo)
You can program the scanner to receive transmissions
in the UHF-Lo band (406-512 MHz) of the Motorola
trunking system. You can receive these transmissions
by checking the trunking system's control channel. You
must program the system's base frequency and offset
frequency to do this.
Notes:
• Base and offset frequencies vary for each type of
trunking system. You can get information about
these frequencies for the trunking system you want
to scan using www.trunkscanner.com , other Internet
sources, or locally-published guidebooks.
54
ôö") ôö")
ôö") ôö")
òôòòòòò òôòòòòò òôòòòòò òôòòòòò
á?ýòñ á?ýòñ á?ýòñ
Next channel
to start scanning.
and the channel number that has been
to accept.
PGM
Trunking Operation
CL
and
CL
and entering the