Radio Shack PRO-2051 User Manual page 56

Beyond the Basics
bank once, while in locked out review mode, hold down L/O
for 3 seconds. All locked out IDs in a bank are restored.
setting the delay mode for trunking mode
A default delay of 2 seconds is automatically set for each
talk group for ID scan mode and ID search mode. To set the
delay feature on or off, press DELAY while trunking. DLY will
appear or disappear, depending on your setting.
trunking frequency confi rmation
You can check the frequency while a talk group ID is active.
Press the key, and the active frequency on which the talk
d
group is transmitting will fl ash on the display. Or press and
hold the key for 2 seconds. The ID and the frequency
d
alternately appear on the display. To cancel this mode, press
the key again.
d
This feature is applied to ID scan mode and ID search
Note Note
mode.
setting priority in trunking mode
You can set priority in your scan lists, just as you do in your
conventional ones. The default setting for the priority ID is
the fi rst location in each scan list. You can set the priority by
pressing and holding PRI for 2 seconds in ID scan hold mode.
After you've set up your scan list, press PRI to activate it. It
is very similar to conventional priority although there is no
"interrupt" during the transmissions. Priorities are checked in
between transmissions.
With priority on, you can hold on an ID in your scan list, such
as scan list 3, memory location 7, and the scanner will check
all the priorities in all the active scan lists in between any
transmissions on the ID on which you're holding. The lowest
numbered priority will be checked fi rst. For example, the
56