Table of Contents
Advertisement
Tracing Tone Test
The Tracing Tone test places a warbled, high-level ID tone on a test pair. You
can choose to apply the following types of tones:
•
A (
Simplex)
intrusive)
•
B (
): Tone applied only between Tip and Ground
T-G
•
C (
): Tone applied only between Ring and Ground
R-G
•
D (
): Tone applied only between Tip and Ring (audible).
T-R
Setting Up a Tracing Tone Test
The Tracing Tone test has no test-specific setup.
Running a Tracing Tone Test
To run a Tracing Tone test on a pair, do the following:
1. Select
Tracing Tone
2. Press the softkey for the type of tone you want to apply, then press K.
A diagram depicting the selected mode is displayed. The transmitting
arrow indicates that the tone is being applied.
3. To stop sending the selected tone, press K.
POTS Testing and Fault Location
: Tone applied equally on T & R with respect to G (non-
from the POTS Toolbox, then press L.
The POTS Toolbox
4
4-39
Advertisement
Table of Contents
