Table of Contents
Advertisement
990DSL
Users Guide
Running a VF Loss Test
To run a VF Loss test, complete the following:
1. Select
VF Loss
A connection diagram is displayed, as shown in Figure 4-26:
Figure 4-26. Connection Diagram for the VF Loss Test
2. Connect the far end sending unit as shown in the diagram.
3. Do one of the following:
•
Select A(
frequency.
OR
•
Select B(
tester.
4. Instruct the sending unit to send the tone or tone-set, then press K.
4-44
from the POTS Toolbox, then press L.
if the sending unit is to send a single
Single Tone)
CopperPro SmartTone
) if the sending unit is a CopperPro
acy108s.eps
Advertisement
Table of Contents
