Connect The Management Ports To The Management Network; Labeling The Ethernet Management Cables - Dell SCv3000 Deployment Manual

NOTE: If deploying vSphere hosts, configure only one host at a
time.
Connect the Management Ports to the Management
Network
Connect the management port on each storage controller to the management network.
About this task
Figure 42. Connect the Management Ports to the Management Network
1 Management network
3 SCv3000 and SCv3020 storage system
Steps
1 Connect the Ethernet switch to the management network.
2 Connect the management ports to the Ethernet switch.
• Connect the management port on the top storage controller to the Ethernet switch.
• Connect the management port on the bottom storage controller to the Ethernet switch.

Labeling the Ethernet Management Cables

Label the Ethernet management cables that connect each storage controller to an Ethernet switch.
Prerequisite
Locate the Ethernet management cable labels that shipped with the SCv3000 and SCv3020 storage system.
About this task
Apply cable labels to both ends of each Ethernet management cable.
Steps
1 Starting with the top edge of the label, attach the label to the cable near the connector.
2 Ethernet switch
Connect the Front-End Cabling 49