Connecting The Storage-System Management Ports - Dell EMC2 AX100 Series Installing Manual

Connecting the Storage-System Management Ports

Before You Start
Cable the Storage-System Management Ports to the Network
AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a Solaris Server
Read this section if you are installing a new storage system.
You manage the storage system from a management host, which can
be a server that has access to the management ports over a specified
10/100 LAN. In addition, when you first set up the storage system,
you must initialize it from a host, which can be a server, connected to
the same network subnet as the storage-system management ports.
The management ports are located on the rear of the chassis and
labeled 10/100.
To complete this procedure, you need a standard CAT 5 or higher
LAN cable for the management port on each storage-system SP that
you will connect to the 10/100 LAN.
For each SP, connect one end of a LAN cable to the 10/100
management port on the SP and the other end to the network from
which you will manage the storage system (Figure 15).
Be sure you do not connect the LAN cable to the serial or UPS ports.
Connecting the Storage-System Management Ports
41