Table of Contents
Advertisement
Figure 40. Attach Label to Cable
2
Wrap the label around the cable until it fully encircles the cable. The bottom of each label is clear so that it does not obscure the text.
Figure 41. Wrap Label Around Cable
3
Apply a matching label to the other end of the cable.
Attach Host Servers (Fibre Channel)
Install the Fibre Channel host bus adapters (HBAs), install the drivers, and make sure that the latest supported firmware is installed.
About this task
•
Contact your solution provider for a list of supported Fibre Channel HBAs.
•
Refer to the
Dell EMC Compatibility Matrix for SC, PS, and FS Series Arrays
•
Refer to the Appendix A
Steps
1
Install Fibre Channel HBAs in the host servers.
NOTE:
Do not install Fibre Channel HBAs from different vendors in the same
server.
2
Install supported drivers for the HBAs and make sure that the HBAs have the latest supported firmware.
3
Use the Fibre Channel cabling diagrams to cable the host servers to the switches. Connecting host servers directly to the storage
system without using Fibre Channel switches is not supported.
HBA Server Settings
for a list of HBA server settings to be used when configuring servers.
for a list of supported Fibre Channel HBAs.
Connect the Front-End Cabling
47
Advertisement
Table of Contents
