• The terminal sounds a tone as explained in the note below.
• When receiving a High Priority Group Call, you will hear a
"High Priority Group Call" tone (if configured by your Service
Provider).
• When receiving a Group Call from your scan list, which is not
from a high priority group, you will hear a "New Group Call"
tone (if configured by your Service Provider).
• To block reception of a Group Call, select Optns then
Block. Powering off/on the terminal unblocks the reception
of this Group Call.
Receiving a Group Call during an On-going Group Call
Depending on how the Service Provider has configured
incoming calls, the incoming call will either be:
• Forced upon you and will interrupt the on-going call (if the
incoming call has higher priority than the on-going call).
OR
• Presented to you (if it has higher
priority than the on-going call).
• To accept the call, press Join.
• To cancel the call, press End.
Receiving an Emergency Group Call
For detailed information, see page 27.
Receiving a Broadcast Call
For detailed information, see page 28.
Transmit Inhibit
You can activate the Transmit Inhibit (TXI) Mode before
entering RF sensitive areas, e.g. in hospitals or in potentially
explosive areas, where safety can be jeopardized due to
MTM800 Enhanced transmission radiation.
End
Group In Use
ID:David
TG4
Join
41