Table of Contents
Advertisement
FM Operation
Switching from DAB to FM Mode
To switch the unit to FM mode, press the DAB/FM button repeatedly to select FM. The display
will show FM and the frequency on the upper segment and the audio mode on the lower
segment.
Auto Scan
To search for an FM station, you need to press the SCAN button. This will start scanning up the
frequency band. To scan down the frequency band, press and hold the SCAN button. Once a
station has been found, the scanning will stop automatically.
If no station is found, then the tuning will stop once it has cycled through the entire FM band
(87.5-108MHz).
Manual Scan
To search FM stations manually, simply press the PREV / NEXT buttons repeatedly or press and
hold until your desired frequency is reached.
With FM radio it may be necessary to fine tune each station by
pressing the PREV / NEXT buttons repeatedly. Each press will adjust the
frequency by 0.05MHz. If reception is still poor adjust the position of the
aerial or try moving the radio to another location.
Audio Mode
Press the ENTER button to toggle between the Auto or Mono selection.
The unit will automatically switch between stereo and mono mode
when it is set to Auto, but you can override this and switch between
them manually. This is helpful when receiving poor signal reception.
Presetting Stations
You can store up to 10 of your favourite stations to the memory. This will enable you to access
your favourite stations quickly and easily.
1.
To store a preset, you must first be listening to the station that you would like to save, then
press and hold the PRESET button and the display will show "Preset Empty #".
Press the PREV / NEXT buttons repeatedly to select your desired preset station number.
2.
3.
Press the ENTER button to confirm the selection.
The station will be stored and the display will show "Preset # stored".
4.
14
Advertisement
Table of Contents
