Yamaha X MAX CZD300-A Owner's Manual page 74

Periodic maintenance and adjustment
3. Remove the engine oil filler cap
and its O-ring, and then remove
the engine oil drain bolt and its
gasket to drain the oil from the
crankcase.
4. Check the O-ring for damage, and
replace it if necessary.
1
2
1. Engine oil filler cap
8
2. O-ring
2
1. Engine oil drain bolt
2. Gasket
TIP
Skip steps 5–7 if the oil filter element is
not being replaced.
5. Remove the oil filter element cover
by removing the bolts.
1
1. Bolt
2. Oil filter element cover
8-10
6. Remove and replace the oil filter
element and O-ring.
1
1. Oil filter element
2. O-ring
7. Install the oil filter element cover
by installing the bolts, then tight-
ening them to the specified
torque.
Tightening torque:
Oil filter element cover bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
2
TIP
Make sure that the O-ring is properly
seated.
8. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
1
2