Yamaha X MAX CZD300-A Owner's Manual page 27

A. After pushing the main switch knob
and confirmation with the smart key
has taken place, the main switch can
be turned while the smart key system
indicator light is on (approximately 4
seconds).
WARNING
Never turn the main switch to
"OFF", " ", or "OPEN" while the ve-
hicle is moving. Otherwise the elec-
trical systems will be switched off,
which may result in loss of control or
an accident.
TIP
Do not push the main switch knob re-
peatedly or turn the main switch back
and forth beyond normal use. Other-
wise, to protect the main switch from
damage, the smart key system will
temporarily disable and the smart key
system indicator light will flash. If this
occurs, wait until the indicator light
stops flashing before operating the
main switch again.
The main switch positions are de-
scribed below.
ON (on)
1
EWA18720
1. Push.
2. Turn.
All electrical circuits are supplied with
the power, and the engine can be start-
ed.
To turn the vehicle power on
1. Turn the smart key on and bring it
within operating range.
2. Push the main switch knob and
the smart key indicator light will
come on for approximately 4 sec-
onds.
EAU76500 3. While the smart key system indi-
2
TIP
 If the vehicle battery voltage is
 See "Emergency mode" on page
OFF (off)
1. Turn.
All electrical systems are off.
4-8
Smart key system
cator light is on, turn the main
switch to "ON". All of the turn sig-
nal lights flash twice and the vehi-
cle power turns on.
low, the turn signal lights will not
flash.
8-36 for information on turning the
vehicle power on without the
smart key.
1
4
EAU76510