Step 4: Installing Antiot - Thermador PRO-HARMONY P304 Installation Instructions Manual

Step 4:
For aH 30" and 36" ranges,
instructions.
Installing Anti-Tip Device
an anti-tip device must be instamled as per these
WARNING
RANGE TtPPtNG HAZARD
AH ranges can tip and injury can result.
To prevent accidenta_ tipping of the range,
attach it to the floor, wall or cabinet by
installing the Anti-Tip Device supplied.
A risk of tip-over may exist if the appli-
ance is not installed in accordance with
these instructions.
mfthe range is pulled away from the wall
for c_eaning, service or any other reason,
ensure that the Anti-Tip Device is prop-
er_y reengaged when the range is pushed
back against the wall. In the event of
abnorma_ usage (such as a person stand-
ing, sitting, or _eaning on an open door),
failure to take this precaution can result
in tipping of the range. Persona_ injury
might result from spilled hot Liquids or
from the range itself.
_, WARNING
o ALL RANGES CAN
T_P
o _NJURY TO PER-
SONS COULD RE-
SULT
o _NSTALL ANT_-T_P
DEVICES PACKED
WiTH RANGE
o SEE _NSTALLAT_ON
_NSTRUCT_ONS
WARNING
ELECTRICAL SHOCK HAZARD
. Use extreme caution when drilling homes
into the wall or floor. There may be con-
ceased e_ectrica_ wires _ocated behind the
wall or under the floor.
. mdentify the e_ectrica_ circuits that could
be affected by the installation of the Anti-
Tip Device, then turn off power to these
circuits.
. Failure to follow these instructions may
result in e_ectrical shock or other per-
sonal injury.
CAUTmON
PROPERTY DAMAGE
. Contact a quaJified installer or contractor
to determine the proper method for drill-
ing hoKes through the wall or floor mate-
ria_ (such as ceramic the, hardwood, etc.)
. Do not s_ide the range across an unpro-
tected floor.
. Failure to follow these instructions may
result in damage to wall or floor cover-
ings.
"Tools Needed for Installation of Anti-Tip Device:
- Screwdriver, Phillips - Hammer
- Drill, electric or hand - Pencil or other marker
- Measuring tape or ruler
- 1/8" drill bit (wood or metal wall or floor)
- %16" carbide-tipped masonry drill bit (concrete or concrete block wall or floor)
- 3/16" anchors, drywall or concrete, 2 each (not required if mounting bracket is being attached to solid wood or
metal)
11