Memory Dialing; Storing A Number In Memory; Entering A Pause; Dialing A Memory Number - Radio Shack Digital Spread Spectrum Cordless Telephone with Digital Answering System Owner's Manual

43-3805.fm Page 15 Wednesday, May 17, 2000 3:48 PM

MEMORY DIALING

The phone can store up to 10 numbers that
you can dial by entering a memory location
number (0–9).

Storing a Number in Memory

Note: An error tone sounds and the phone
exits the storing process if you wait more
than 20 seconds between each key press.
1. Lift the handset and press
TALK/BATT indicator blinks.
2. Enter the number and any tone mode
changes or pause entries (see "Entering
a Pause").
Notes:
• Each number you store can be up to
20 digits long.
• If you try to enter more than 20 digits,
the phone beeps several times and
exits the storing process. Start over
from Step 2.
• Each tone or pause entry uses one
digit of memory.
3. Press , then enter the memory loca-
MEM
tion number ( – ). The handset sounds
0 9
a long beep to indicate that the number
is stored.
4. For each stored number,
write the person's or
company's name next to
the appropriate location
number on the supplied
memory directory sticker.
Peel the backing off the
sticker and attach it to
the phone.
To replace a stored number, simply store a
new one in its place.
To delete a stored number, lift the handset
and press
location number (0–9) you want to clear. The
handset sounds a long beep to signal that
the memory location is clear.

Entering a Pause

In some telephone systems, you must dial an
access code (9, for example) and wait for a
second dial tone before you can dial an out-
side number. You can store the access code
. The
MEM
with the phone number. However, you
should also store a pause after the access
code to allow the outside line time to con-
nect. To enter a 2-second pause, press
. For a longer pause, press
PAUSE
ditional times.

Dialing a Memory Number

To dial a number stored in a standard memo-
ry location, press
dial tone, press
location number for the number you want to
dial.
Note: If you select an invalid or empty mem-
ory location, the phone sounds an error tone.
Press
MEM
number again.

Chain-Dialing Service Numbers

For quick recall of numbers for special ser-
vices (such as alternate long distance or
bank-by-phone), store each group of num-
bers in its own memory location.
Dial the service's main number first. Then, at
the appropriate place in the call, press
and enter the memory location number (0–9)
for the stored information.
Operation
MEM twice, then enter the memory
PAUSE
. When you hear a
TALK
and enter the memory
MEM
and enter the memory location
ad-
MEM
15