Using Both The Handset And Speakerphone; Using Tone Services On A Pulse Line; Using Redial; Using Mute - Radio Shack Digital Spread Spectrum Cordless Telephone with Digital Answering System Owner's Manual

Digital spread spectrum cordless telephone with digital answering system
Table of Contents

Advertisement

43-3805.fm Page 14 Wednesday, May 17, 2000 3:48 PM
USING BOTH THE HANDSET
AND SPEAKERPHONE
If someone else is using the speakerphone,
press
on the handset to join the con-
TALK
versation. If someone else is using the hand-
set, press
on the base to join the
SPEAKER
conversation.
During the call, one person can hang up and
let the call continue at the other keypad. Or,
both people can hang up to end the call.
Note: If you hear a high-pitched noise from
the base's speaker, the handset and the
base are too close together.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-by-
phone, require tone signals. If you have
pulse service, you can still use these special
tone services by following these steps.
1. Be sure
DIAL MODE
2. Dial the service's main number. When
the service answers, press
handset. Any additional numbers you
dial are sent as tone signals.
3. When you hang up, the phone automati-
cally resets to pulse dialing.

USING REDIAL

You can quickly dial the last number dialed.
When you hear a dial tone, press
Notes:
• The redial memory holds up to 32 digits,
so you can redial long-distance as well
as local numbers.
• The redial memory also holds pause
entries. See "Entering a Pause" on
Page 15.
14
is set to
.
P
on the
TONE
.
REDIAL
Operation

USING MUTE

To talk to someone in the room without the
person on the other end of the phone line
hearing your conversation, press
TALK/BATT indicator flashes. Press
again or
to resume your phone conver-
TALK
sation.

USING FLASH

performs the electronic equivalent of
FLASH
a switchhook operation for special services,
such as Call Waiting.
For example, if you have Call Waiting, press
to answer an incoming call without
FLASH
disconnecting the current call. Press
again to return to the first call.
Note: If you do not have any special phone
services, pressing
FLASH
the current call.

PAGING

To page the person who has the handset (or
to locate the handset when the phone is not
in use), press
on the base for less than
PAGE
2 seconds. The handset beeps for about 5
seconds. To sound the beep for 1 minute,
press
more than 2 seconds. Or, hold
PAGE
down
for over 1 minute to make the
PAGE
handset beep until you release
To stop the beeping sooner, press any key
on the handset except
TALK
Notes:
• The phone goes off-hook (you hear the
dial tone) the first time you press
to stop the handset from beeping. If you
do not press
TALK
remains off-hook.
• The phone rings if a call comes in during
paging.
. The
MUTE
MUTE
FLASH
might disconnect
PAGE
.
.
TALK
again, the phone

Advertisement

Table of Contents
loading

This manual is also suitable for:

43-3805

Table of Contents