Setting The Record Time; Recording/Deleting An Outgoing Message - Radio Shack 43-3820 Owner's Manual

6WTPKPI"VJG"/GUUCIG"#NGTV"6QPG"1HH"
The Message Alert tone automatically stops when
you have listened to all the new messages.
To turn off the Message Alert tone sooner, press
any key on the base. The Message Alert tone
automatically sounds when the next message is
received.
5 "
'.'%6+0) 6*'
/
'55#)'
The system has two prerecorded outgoing
messages. One asks the caller to leave a message:
"Hello, no one is available to take your call. Please
leave a message after the tone." The system uses
this message when the recording time is set to
(see "Setting the Record Time" on Page 28).
The other announcement does not allow the caller
to leave a message: "Hello, no one is available to
take your call. Please call again." The system uses
this message when the recording time is set to
Announce Only.
You can also record your own message (see
"Recording/Deleting an Outgoing Message" on
Page 29). When you record your own outgoing
message and select it, the system uses it for all
recording time settings (
To switch between your outgoing message and the
system's prerecorded message, press
current message plays. While the message is
playing, press
OGM
4 1&
'%14&+0)
1 "/
76)1+0)
1. Hold down
OGM
"Record greeting," followed by a beep.
flashes.±ý
2. Speak your message.
"1
76)1+0)
' ' ' ' * * * * 7 7 7 7
, , and ).
again.
" "
'.'6+0) #0
'55#)'
. The system announces
"
' ' ' ' * * * *
or
. The
OGM
Recording/Deleting an
#ý# #ý# #ý# #ý#
Outgoing Message
Outgoing messages must
be between 2 and 30
seconds long.
± ±
"016'" "
29