Testing Stored Emergency Numbers; Using A Headset; Answering System Operation; Selecting The Outgoing Message - Radio Shack Digital Spread Spectrum Cordless Telephone with Digital Answering System Owner's Manual

43-3805.fm Page 16 Wednesday, May 17, 2000 3:48 PM
Testing Stored Emergency Num-
bers
If you store an emergency service's number
(police department, fire department, ambu-
lance) and you choose to test the stored
number, make the test call during the late
evening or early morning hours to avoid peak
demand periods. Also, remain on the line to
explain the reason for your call.

USING A HEADSET

You can talk with hands-free convenience
using an optional headset with a
(2.5-mm) plug. Your local RadioShack store
has a variety headsets.
To connect the headset, open the rubber
cover marked on the side of the hand-
set, then insert the headset's plug into the
jack.
ˆ

Answering System Operation

SELECTING THE OUTGOING
MESSAGE
The answering system has two prerecorded
outgoing messages. One asks the caller to
leave a message: "Hello, no one is available
to take your call. Please leave a message af-
ter the tone." The system uses this message
when is set to
REC TIME
the Record Time" on Page 17).
16
Notes:
3
With a headset connected, you can make or
/ -inch
32
answer calls as usual using the keys on the
handset.
You can use a handset holder (available at
your local RadioShack store) to hang the
handset on your belt for greater conve-
nience.
When you finish using the headset, discon-
nect it and close the rubber cover to protect
the jack.
The other message is an announcement and
does not let the caller leave a message: "Hel-
lo, no one is available to take your call." The
system uses this message when
set to
You can also record your own message (see
"Recording/Deleting an Outgoing Message"
on Page 17). When you record your own out-
or (see "Setting
1 4
going message, the system uses it for all
REC TIME
To switch between your outgoing message
and the answering system's prerecorded
message, press
message begins to play, press
REC TIME
ANN/4/1
Answering System Operation
• Connecting a headset disconnects the
handset's earpiece and microphone.
8 8 8 8 9 9 9 9
• or on the handset also controls
the connected headset's volume.
• Pressing on the handset also
MUTE
silences the headset's microphone.
• If you place the handset on the base
while the headset is connected, be sure
the handset seats properly.
(announcement only).
ANN
settings.
. When the current
OGM
is
REC TIME
again.
OGM