Setting The Dialing Mode; Turning The Base'sringer On And Off; Setting The Handset'sringer Tone/Volume - Radio Shack Digital Answering System with Caller ID Deluxe and 2.4 GHz Digital Spread Spectrum Cordless Phone Owner's Manual

Important: The EPA certified
®
RBRC Battery Recycling Seal
on the nickel-cadmium (Ni-Cd)
battery indicates RadioShack
is voluntarily participating in an
industry program to collect and recycle these
batteries at the end of their useful life, when
taken out of service in the United States or
Canada. The RBRC program provides a
convenient alternative to placing used Ni-Cd
batteries into the trash or the municipal
waste stream, which may be illegal in your
area. Please call 1-800-THE-SHACK (1-
800-843-7422) for information on Ni-Cd bat-
tery recycling and disposal bans/restrictions
in your area. RadioShack's involvement in
this program is part of the company's com-
mitment to preserving our environment and
conserving our natural resources.
SETTING THE DIALING
MODE
Set on the back of the base for
PULSE-TONE
the type of service you have. If you are not
sure which type you have, after you charge
the handset battery pack, do this test.
1. Set to
PULSE-TONE
2. Lift the handset, press
for a dial tone.
3. Press any number other than
Note: If your phone system requires that
you dial an access code (
before you dial an outside number, do
not press the access code number
either.
If the dial tone stops , you have touch-
tone service. Leave
.
TONE
If the dial tone continues , you have
pulse service. Set
.
PULSE
.
TONE
, then listen
TALK
.
0
, for example)
9
set to
PULSE-TONE
to
PULSE-TONE
Installation
4. Press or place the handset on the
TALK
base to hang up.
TURNING THE BASE'S
RINGER ON AND OFF
To turn off the base's ringer, set
the back of the base to
make or receive calls using this phone. Tele-
phones on the same line (and the answering
system's handset if it is away from the base)
still ring when there is an incoming call.
To turn on the base's ringer, set
.
ON
SETTING THE HANDSET'S
RINGER TONE/VOLUME
You can select one of four different ringer
tone/volume settings on the handset. At any
time, except during a call, repeatedly press
8 8 8 8 9 9 9 9
or to select the desired ringer
VOL/CID
setting. Each time you press
9 9 9 9
, the phone rings at the selected setting
H_d][h H_d][h 7 7 7 7 >_]^ H_d][h H_d][h >_]^ >_]^ >_]^ H_d][h H_d][h 7 7 7 7 Bem H_d][h H_d][h
and ,
H_d][h 8 8 8 8 Bem H_d][h H_d][h H_d][h Bem Bem Bem
or appears.
You can also turn off the ringer. At any time,
except during a call, press and hold
9 9 9 9
until the phone beeps and
pears. When you place the handset faceup
2 2 2 2 H_d][h H_d][h E\\ E\\4 4 4 4
H_d][h H_d][h E\\ E\\
on the base,
You can still make or receive a call even
when the ringer is turned off. When you have
an incoming call, any other phone connected
to the same line rings and
pears.
To turn the ringer back on, simply press
8 8 8 8 9 9 9 9
or . The ringer resets to
CID
>_]^ >_]^
>_]^ >_]^
.
on
RINGER
. You can still
OFF
to
RINGER
8 8 8 8
VOL/CID or
Bem Bem Bem H_d][h 8 8 8 8 >_]^ H_d][h H_d][h H_d][h >_]^ >_]^ >_]^
, ,
VOL/CID
2 2 2 2 H_d][hýE\\ H_d][hýE\\4 4 4 4
H_d][hýE\\ H_d][hýE\\
ap-
appears.
?dYec_d] 9Wbb ?dYec_d] 9Wbb
?dYec_d] ?dYec_d] 9Wbb 9Wbb
ap-
VOL/
H H H H _d][h _d][h _d][h 7 7 7 7 _d][h
13