5. Route the adapter's cord through the
strain relief slot on the bottom of the
bracket.
6. Plug the adapter into a standard AC out-
let.
7. Lift the base's antenna to a vertical posi-
tion.
On a Wall Plate or Wall
1. Insert the bracket's tabs into the base's
lower tab slots, then press down on the
bracket's clips and insert them into the
clip slots.
2. Plug one end of the supplied short mod-
ular cord into the
TEL LINE
back of the base.
3. Insert the supplied AC adapter's barrel
plug into the
DC IN 9V
4. Route the adapter cord through the
groove on the bracket.
5. Plug the modular cord's other end into
the wall plate jack, then align the
bracket's keyhole slots with the wall
10
6. Plug the adapter into a standard AC out-
7. Lift the base's antenna to a vertical posi-
Note: To mount the phone directly on a wall,
you need two screws (not supplied) with
heads that fit into the keyhole slots on the
bottom of the base.
Follow the steps under "On a Wall Plate or
Wall," then apply these additional instruc-
tions.
1. Drill two holes 3
jack on the
2. Plug one end of the supplied long modu-
jack.
3. Align the bracket's keyhole slots with the
Installation
plate studs and slide the phone down-
ward to secure it.
let.
tion.
15
/
inches (100 mm)
16
apart. Then thread a screw into each
hole, letting the heads extend about
inch (3 mm) from the wall.
lar cord into the
TEL LINE
back of the base and route the adapter
cable and modular cords through the
grooves on the bracket.
mounting screws and slide the phone
downward to secure it.
1
/
8
jack on the