Table of Contents
Advertisement
43-935.fm Page 10 Friday, January 14, 2000 3:07 PM
On a Desk Top
Follow these steps to mount the system
on a desktop.
1. Plug one end of the supplied long
modular cord into the
on the back of the phone.
2. Plug the other end of the modular
cord into a modular phone jack.
3. Place the phone on a flat desk,
shelf, or table.
On a Wall Plate
Follow these steps to mount the system
on a standard wall plate.
1. Plug one end of the supplied short
modular cord into the
on the back of the system. Then
route the cord through the strain re-
lief groove on the bottom of the
phone.
2. Feed any excess modular cord into
the cavity at the base of the strain
relief groove.
3. Plug the other end of the modular
cord into the wall plate's modular
jack.
10
4. Align the base's keyhole slots with
5. Press and lift out the handset hold-
jack
TEL LINE
On the Wall
To install the system directly on the wall,
jack
TEL LINE
you need two screws (not supplied) with
heads that fit into the keyhole slots on
the bottom of the phone and the stand.
1. Drill two holes 3
Strain Relief
Groove
2. Plug one end of the supplied long
Key Hole Slots
3. Align the bracket's keyhole slots
4. Plug the other end of the modular
the wall plate studs and slide the
base downward to secure it.
er. Rotate it 180°, then snap it back
into place so it holds the handset.
Handset
Holder
15
/
inch-
16
es (100 mm) apart. Then
thread a screw into each
hole, letting the heads ex-
1
tend about
/
inch (3.5
8
mm) from the wall.
modular cord into the
on the back of the system.
with the mounting screws and slide
the base downward to secure it.
cord into a nearby modular jack.
1
/
8
15
3
/
16
jack
TEL LINE
Advertisement
Table of Contents
