Installation; Mounting The Phone; On A Desktop - Radio Shack 900 MHz Digital Spread Spectrum Cordless Phone with Dual Caller ID Owner's Manual

ˆ

Installation

Note: The base's display is protected during
shipment by a piece of film. Carefully peel off
this film before using your phone for the first
time.

MOUNTING THE PHONE

You can place the phone's base on a desk or
table, mount it on a standard wall plate, or
mount it directly on a wall.
Choose a location that is:
• near an AC outlet
• near a modular telephone line jack
• out of the way of normal activities
• away from electrical machinery, electri-
cal appliances, metal walls or filing cabi-
nets, wireless intercoms, alarms, and
room monitors
• away from other cordless phones
The base's location affects the phone's
range. If you have a choice of several loca-
tions, try each to see which provides the best
performance.
Cautions:
You must use a Class 2 power
!
source that supplies 9V AC
and delivers at least 350 mA.
Its center tip must be set to positive and
its plug must fit the phone's
jack. The supplied adapter meets these
specifications. Using an adapter that
does not meet these specifications
could damage the phone or the adapter.
• Always connect the AC adapter to the
phone before you connect it to AC
power. When you finish, disconnect the
adapter from AC power before you dis-
connect it from the phone.
Your telephone connects directly to a modu-
lar telephone line jack. If your telephone wir-
ing does not have a modular jack, you can
update the wiring yourself using jacks and
adapters (available at your local RadioShack
store), or have the telephone company up-
date the wiring for you. You must use com-
patible modular jacks that are compliant with
Part 68 of FCC Rules .
Note: The USOC number of the jack to be
installed is RJ11C (or RJ11W for a wall plate
jack).

On a Desktop

1. Insert the bracket's tabs into the base's
upper tab slots, then press down on the
bracket's clips and insert them into the
clip slots.
2. Plug one end of the supplied long modu-
lar cord into the
back of the base and route the cord
DC IN 9V
through the strain relief hook on the
bracket.
3. Plug the modular cord's other end into a
modular telephone line jack.
4. Insert the supplied AC adapter's barrel
plug into the
the base.
Installation
jack on the
TEL LINE
jack on the back of
DC IN 9V
9