On A Wall Plate - Radio Shack 4301122D Owner's Manual

43-1122.C.fm Page 8 Wednesday, December 13, 2000 1:56 PM

On a Wall Plate

1. Plug one end of the supplied short mod-
ular cord into the
TEL LINE
back of the base.
2. Insert the supplied AC adapter's barrel
plug into the
DC IN 9V
the base.
3. Route the adapter and modular cords
through the grooves on the bottom of
the base.
AC Cord
4. Plug the short modular cord into the wall
plate jack, then align the base's keyhole
slots with the wall plate studs and slide
the base down to secure it.
5. Plug the adapter into a standard AC out-
let.
6. Push up on the handset holder, then lift
and remove it. Turn it over and rotate it
so that the oval-shaped indention is at
8
jack on the
On a Wall
To mount the phone directly on a wall, you
jack on the back of
need two screws (not supplied) with heads
that fit into the keyhole slots on the bottom of
the base.
Modular
Telephone
Cord
Installation
the bottom, then slide it down into its
slot. Snap it back into place so that it
holds the handset.
15
1. Drill two holes 3 /
inches (100 mm) apart.
Then thread a screw
into each hole, letting
the heads extend about
1
/ inch (3 mm) from the
8
wall.
2. Plug one end of the supplied long modu-
lar cord into the
TEL LINE
back of the base.
3. Insert the supplied AC adapter's barrel
plug into the
DC IN 9V
the base.
4. Route the adapter and modular cords
through the grooves on the bottom of
the base.
5. Align the bracket's keyhole slots with the
mounting screws and slide the base
downward to secure it.
16
jack on the
jack on the back of