On A Wall Plate Or Wall - Radio Shack TAD-729 Owner's Manual

On a Wall Plate or Wall

1. Insert the two tabs at the top of the
narrow end of the supplied bracket
into the base's upper tab slots as
shown, then press down on the
bracket's latches and insert them
into the lower slots.
2. Plug one end of the supplied short
modular cord into the
on the back of the base as in Step 1
of "On a Desk Top" on Page 8.
3. Insert the supplied AC adapter's
barrel plug into the
in Step 3 of "On a Desk Top" on
Page 8.
4. Route the adapter and modular
cords through the grooves on the
bracket.
5. Plug the modular cord's other end
6. Plug the adapter into a standard AC
7. Press and lift out the handset
jack
TEL LINE
jack as
DC IN 9V
8. Lift the base's antenna to a vertical
into the wall plate jack, then align
the bracket's keyhole slots with the
wall plate studs and slide the base
downward to secure it.
outlet.
holder, flip it over as shown, then
snap it back into place so it holds
the handset.
Handset Holder
position.
9