Reprocessing the mask between patients
This mask should be reprocessed when used between patients. Cleaning,
disinfection and sterilisation instructions are available from the ResMed
website, www.resmed.com/masks/sterilization. If you do not have
internet access, please contact your ResMed representative.
Troubleshooting
Problem/possible cause
Mask is uncomfortable
Headgear straps are too tight.
Mask could be the wrong size.
Mask is too noisy
Elbow incorrectly installed.
Vent is blocked or partially blocked.
Mask leaks around the face.
Cushion membrane is creased or
folded.
Mask could be the wrong size.
Frame incorrectly fitted.
6
Solution
The cushion membrane is designed to inflate
against your face to provide a comfortable seal
with low headgear tension. Adjust straps evenly.
Ensure that the headgear straps are not too tight
and that the cushion is not crushed or creased.
Talk to your clinician to have your face size
checked against fitting template. Note that sizing
across different masks is not always the same.
Remove the elbow from your mask, then
reassemble according to the instructions.
Clean with a soft bristle brush until the vent is
clear.
Refit your mask according to the instructions.
Ensure that you position the cushion correctly on
your face before pulling headgear over your
head. Do not slide the mask down your face
during fitting as this may lead to folding or
curling of the cushion.
Talk to your clinician to have your face size
checked against fitting template. Note that sizing
across different masks is not always the same.
Remove the rest of the mask from the frame,
then reassemble according to the instructions.