Reprocessing The Mask Between Patients; Troubleshooting - ResMed AirFit P10 User Manual

Reprocessing the mask between patients

Only Sleep Lab Mask (SLM) variants of the mask system are intended for
multi-patient re-use. When using between patients, these masks must be
reprocessed according to cleaning and disinfection instructions available
on ResMed.com/downloads/masks.

Troubleshooting

Problem/possible cause
Pillows won't seal properly, mask is uncomfortable or causes red marks
Pillows may have been fitted
incorrectly, adjusted incorrectly
or the headgear is fitted
incorrectly.
Inner wall position of one or
both pillows is incorrect.
Pillows are the wrong size.
Pillows may be dirty.
Headgear is too loose.
Vent is blocked or
dirty/discolored.
Vent is wet.
Mask too noisy
System is assembled incorrectly. Disassemble the mask, then reassemble according to
System is leaking air.
6
Solution
Check that the nasal pillows with the left (L) and right
(R) indicators are inserted correctly (L into your left
nostril, R into your right nostril). Carefully follow the
fitting instructions. Readjust the headgear to ensure it
is fitted comfortably.
Squeeze pillow sides to release inner wall. The correct
position is shown in the reassembly instructions.
Talk to your clinician.
Clean pillows according to the instructions.
Adjust the headgear split bands.
If your headgear does not come with a buckle, wash
the headgear to help it return to its original form.
Follow the washing instructions.
If your headgear comes with a buckle, adjust the
headgear by pulling the headgear through the buckle.
Adjust only enough for a comfortable seal and do not
overtighten. You may need to adjust the headgear as it
stretches over time.
If the vent requires cleaning, use a soft bristle brush.
The vent may discolor over time and this is not a safety
concern. Follow the cleaning instructions in this guide
to maintain performance and safety of the mask.
Ensure the vent is dry after cleaning and in the case of
excess condensation.
the instructions.
Refit or reposition your mask. Adjust your headgear.
Check your mask is assembled correctly.