Page 6
Cleaning the vent / Luftauslassöffnung reinigen / Nettoyage de l'orifice de ventilation / Pulizia del foro per l'esalazione / De ventilatieopening schoonmaken / تنظيف ثقوب التھوية...
WARNING Magnets are used in the lower headgear straps and the frame of the AirTouch F20. Ensure the headgear and frame is kept at least 50 mm away from any active medical implant (eg, pacemaker or defibrillator) to avoid possible effects from localized magnetic fields.
Page 8
Contraindications Use of masks with magnetic components is contraindicated in patients with the following pre-existing conditions: • a metallic hemostatic clip implanted in your head to repair an aneurysm • metallic splinters in one or both eyes following a penetrating eye injury.
Page 9
• Remove all packaging before using the mask. Using your mask When using your mask with ResMed CPAP or bilevel devices that have mask setting options, refer to the Technical specifications section in this user guide for the correct setting.
Page 10
Fitting 1. Twist and pull both magnetic clips away from the frame. 2. Ensure that the ResMed logo on the headgear is facing outwards and is upright. With both lower headgear straps released, hold the mask against your face and pull the headgear over your head.
Page 11
1. Attach the cushion to the frame by aligning the circular openings and pushing together until retained. 2. With the ResMed logo on the headgear facing outside and upright, thread the upper headgear straps into the frame slots from the inside.
Page 12
• Regularly clean your mask and its components to maintain the quality of your mask and to prevent the growth of germs that can adversely affect your health. CAUTION • Visible criteria for product inspection: If any visible deterioration of a system component is apparent (cracking, discoloration, tears, etc.), the component should be discarded and replaced.
Replace the cushion by following relevant steps of the disassembly / reassembly instructions. Reprocessing the mask between patients Reprocess this mask when using between patients. Cleaning, disinfection and sterilization instructions are available on www.resmed.com/downloads/masks. If you do not have internet access, please contact your ResMed representative. Troubleshooting Problem/possible cause Solution Mask is uncomfortable.
Problem/possible cause Solution Mask could be the wrong size. Talk to your clinician to have your face size checked against fitting template. Note that sizing across different masks is not always the same. Technical specifications Pressure-flow curve The mask contains passive venting to protect against rebreathing.
Page 15
Protection (ICNIRP) Service life The service life of the AirTouch F20 mask system is dependent on the intensity of usage, maintenance, and environmental conditions to which the mask is used or stored. As this mask system and its components are modular in nature, it is recommended that the user...
Page 16
Mask setting For AirSense, AirCurve or S9: Select 'Full Face'. For other devices: Select 'MIR FULL' (if available), otherwise select options 'FULL FACE' as the mask option. Notes: • This product is not made with PVC or phthalates such as DEHP, DBP or BBP.
Page 17
Symbols The following symbols may appear on your product or packaging: Catalog number Batch code Humidity limitation Temperature limitation Not made with natural rubber Fragile, handle with care latex European Authorized Manufacturer Representative Keep away from rain This way up Full face mask Device setting - Full Face Size - small...
Page 18
Consumer Warranty ResMed acknowledges all consumer rights granted under the EU Directive 1999/44/EC and the respective national laws within the EU for products sold within the European Union.